FlexSEA Wiki

A WEARABLE ROBOTICS TOOLKIT

User Tools

Site Tools


bluetoothconfignew

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
bluetoothconfignew [2018/03/05 13:44]
jfduval
bluetoothconfignew [2019/01/15 15:24] (current)
jfduval [Using the Plan GUI to configure a Bluetooth module]
Line 14: Line 14:
 {{ :​configbluetoothgui.gif |}} {{ :​configbluetoothgui.gif |}}
  
-At this point you can re-open the COM port and start using the GUI. Power cycling is not typically needed. Windows might keep listing your module as an RBNT-xxxx for a little while, but it will eventually refresh it to be FlexSEA-xxxx. All other computers should see it as FlexSEA-xxxx ​immediatly.+At this point you can re-open the COM port and start using the GUI. Power cycling is not typically needed. Windows might keep listing your module as an RBNT-xxxx for a little while, but it will eventually refresh it to be FlexSEA-xxxx. All other computers should see it as FlexSEA-xxxx ​almost immediately.
  
  
bluetoothconfignew.txt ยท Last modified: 2019/01/15 15:24 by jfduval