FlexSEA Wiki

A WEARABLE ROBOTICS TOOLKIT

User Tools

Site Tools


dephyactpack

This is an old revision of the document!


Dephy Actuator Package

The Dephy Actuator Package is a turn-key solution for people who want to test FlexSEA's capabilities or quickly design a prosthetic limb. The Package consists of a custom brushless motor integrated with a FlexSEA-Rigid circuit and a minimalist enclosure, pre-loaded embedded software, and a full suite of high-level software and test scripts.

Features

  • Fully integrated brushless motor (BLDC), power electronics and control logic
  • Plug and play solution: no programming needed for most applications
  • Cross-platform graphical user interface and full suite of Python demo scripts
  • Built-in high-performance controllers: current, position, impedance, and voltage.
  • Built-in sensors and interfaces: 6-axis IMU, voltage, current, temperature, strain gauge amplifier, etc.
  • Communication: Bluetooth, USB, RS-485, SPI, UART and I2C
  • Safety features: battery I²t, motor I²t, voltage limits, temperature

Specifications

Table 1. Motor

Mass 230 g
Terminal resistance 186 mΩ
Terminal Inductance 138 µH
Torque Constant 95 mNm/A
Diameter 87 mm
Length 17 mm
Rotor inertia 1E-4 kg m2

Table 2. Housing

Mass 50 g
Material 7075-T6 Aluminum
Finish Black anodization

Table 3. Embedded System

Mass 41 g
Voltage 20-50 V (5s-12s LiPo)
Commutation type 4-quadrant Field-Oriented control (4Q FOC)
PWM frequency 20 kHz
Max continuous current 10 A (Note 1)
Peak current 30 A (Note 1)
High level controller STM32F427 180 MHz Cortex-M4 with floating-point unit (FPU)
IMU MPU-9250 6-axis (3-axis accelerometer, 3-axis gyroscope) (Note 2)
Bluetooth RN-42 Class 2 EDR Bluetooth module
Strain-gauge amplifier One full-bridge channel, 5V excitation Gain = 203
Motor encoder Absolute magnetic encoder, 14-bits
Current sensing and control Motor: 3-ch 12-bits sensing, 20kHz PI controller
Battery: ±20A, 900Hz bandwidth, 12-bits
Safety protections (HW) 52V TVS, 10A slow-blow fuse
Intrinsic sensors Battery voltage, intermediate voltage, +5V bus, temperature, etc.

(1) Higher currents can be used with a heatsink. (2) Magnetometer disabled by software – overpowered by the motor’s magnetic field

Quick start guide

Below are high level instructions and resources to get users started, as well as additional information to facilitate troubleshooting.

  1. Get the device powered up. This can be accomplished using a power supply or a USB cable. Then turn the device on by pressing the power button.
    • If necessary the Actuator Package's firmware can be updated.
    • Note: Keep in mind that the USB cable cannot power the motor.
    • Note: The device's LEDs indicate its state and can be useful for debugging.
  2. Install and run the Plan GUI.
  3. Communication between your computer and the Actuator Package can be established over USB or Bluetooth.
  4. The connection can be validated by streaming data.
  5. Plan can also be used to control motors.
  6. With those functionalities verified, the demo scripts can be run. This allows the user to bypass the GUI and can serve as a template for future code in your target language.

Example Applications

Additional Resources

dephyactpack.1548431470.txt.gz · Last modified: 2019/01/25 15:51 by jfduval