FlexSEA Wiki

A WEARABLE ROBOTICS TOOLKIT

User Tools

Site Tools


faq

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
faq [2019/10/07 13:39]
jfduval [Terminology]
faq [2019/10/07 13:41] (current)
jfduval [Strange behavior after programming a microcontroller]
Line 49: Line 49:
 Please note that having a USB cable connected will prevent a full power cycle! Always disconnect USB when you want to power cycle. Please note that having a USB cable connected will prevent a full power cycle! Always disconnect USB when you want to power cycle.
  
 +==== Circuit turned off after programming ====
 +To prevent undetected I2C lock-ups, in recent firmware releases we automatically reset the boards after Mn is programmed.
 ==== I programmed the board, but my LEDs are not blinking. ==== ==== I programmed the board, but my LEDs are not blinking. ====
   * Start by reviewing the [[led|RGB LED Convention]] page.   * Start by reviewing the [[led|RGB LED Convention]] page.
faq.txt ยท Last modified: 2019/10/07 13:41 by jfduval