FlexSEA Wiki

A WEARABLE ROBOTICS TOOLKIT

User Tools

Site Tools


stm32driver

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
stm32driver [2019/01/08 21:06]
flabelle
stm32driver [2019/05/06 15:21] (current)
kandoni New install procedure for STM32 driver
Line 10: Line 10:
  
   - [[https://​www.st.com/​en/​development-tools/​stsw-stm32102.html|Obtain a copy of the driver]]   - [[https://​www.st.com/​en/​development-tools/​stsw-stm32102.html|Obtain a copy of the driver]]
-  - Install the Virtual Com Port driver to be able to connect to the STM32 chip on the FlexSEA. Do this by running the application:​ VCP_V1.4.0_Setup.exe +  ​- Click **Get Software** and enter the requested information. An email will be sent to verify your email address. 
-  - Now go to the installation directory, which is most likely: **C:​\Program Files(x86)\STMicroelectronics\Software\Virtual comport driver\Win8**...+  - In the email, click **Download Now**. A zip file containing the driver contents will download. 
 +  - Open the **en.stsw-stm32102.zip** file and extract the contents. 
 +  ​- Install the Virtual Com Port driver to be able to connect to the STM32 chip on the FlexSEA. Do this by running the application: ​**VCP_V1.5.0_Setup_<​...>​.exe** where **<​...>​** corresponds with your machine OS and architecture. 
 +  - Unplug and re-plug your device. Make sure that Windows detects a valid COM port, the device should appear as "​STMicroelectronics Virtual COM Port (COMx)"​ in the Device manager. If you see a yellow exclamation mark it means that your driver is not properly installed. 
 + 
 +__Troubleshooting:​__ 
 + 
 +In case there is an issue installing the driver, try the following steps: 
 +  - Go to the installation directory, which is most likely: **C:​\Program Files(x86)\STMicroelectronics\Software\Virtual comport driver\Win8**...
   - ... and run the application corresponding to your operating system: **dpinst_amd64.exe** for 64 bit windows. **dpinst_x86.exe** for 32 bit windows   - ... and run the application corresponding to your operating system: **dpinst_amd64.exe** for 64 bit windows. **dpinst_x86.exe** for 32 bit windows
   - Unplug and re-plug your device. Make sure that Windows detects a valid COM port, the device should appear as "​STMicroelectronics Virtual COM Port (COMx)"​ in the Device manager. If you see a yellow exclamation mark it means that your driver is not properly installed.   - Unplug and re-plug your device. Make sure that Windows detects a valid COM port, the device should appear as "​STMicroelectronics Virtual COM Port (COMx)"​ in the Device manager. If you see a yellow exclamation mark it means that your driver is not properly installed.
 +
  
stm32driver.txt · Last modified: 2019/05/06 15:21 by kandoni