FlexSEA Wiki

A WEARABLE ROBOTICS TOOLKIT

User Tools

Site Tools


build_fx_plan

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
build_fx_plan [2020/05/25 16:10]
jfduval [CLion IDE]
build_fx_plan [2020/06/22 11:47] (current)
sbelanger
Line 100: Line 100:
     * Important: you need to have the submodules in the right location (side by side).     * Important: you need to have the submodules in the right location (side by side).
     * Easiest way to do this is to clone ''​FlexSEA''​ and to open ''​FlexSEA\fx_plan_stack''​ as your project.     * Easiest way to do this is to clone ''​FlexSEA''​ and to open ''​FlexSEA\fx_plan_stack''​ as your project.
-  - Confirm that the CMake project was loaded (lower console).+  - Confirm that the CMake project was loaded (lower console). You may have to remove some environment variable to make it work.
  
 You can now use CLion as your IDE. As a quick test, open src/​device.cpp. Ctrl+click on circ_buff_init() as a test; it will bring you to the flexsea-comm submodule. You can now use CLion as your IDE. As a quick test, open src/​device.cpp. Ctrl+click on circ_buff_init() as a test; it will bring you to the flexsea-comm submodule.
build_fx_plan.txt ยท Last modified: 2020/06/22 11:47 by sbelanger